Wallrock Thermal FR Adhesive 5kg is an extra strong adhesive with added flame retardant properties, to help protect combustible surfaces.

The Adhesive has been designed to create a permanent bond for our technical linings, and also incorporates active fire retardants.

Enhanced with fire retardants FR Adhesive assists with the dampening of flames used to hang Wallrock Fireliner and Insulating Lining Paper Graphite Plus.

Both of these popular products have been used in conjunction with Wallrock Thermal FR Adhesive as part of a system which has been tested to BS476.

The incorporated flame retardant additives are integrated into two separate mechanisms, each having a synergistic effect on the other.

The first endothermically removes heat from the reaction and the second creates a thermal insulation barrier between the burning and the unburnt components.

Wallrock Thermal FR Adhesive can also be used to hang other products, where an enhanced fire protection is preferred.

Typical consumption on Wallrock Fireliner is 0.5kg per square metre.

Specification:

Coverage: 0.5kg per m²

Material: FR Adhesive

Profile: Ready-to-use

Applications: Walls and ceilings

Wallrock Thermal FR Adhesive Features:

 · High performance aqueous adhesive with fillers and added fire retardants.

 · Thick, smooth, low splatter formula - roll or brush straight from the tub.

 · High 'wet-tack' to hold in place while cutting and positioning.

 · High resin content for optimum adhesion to surfaces.

 · Contains an inhibitor to prevent mould, yeast and fungal growth.

 · Available in 5kg tubs.

Wallrock FR Fire Adhesive Installation Guide:

 · Surface Preparation - surfaces should be clean, dry, sound and free from loose paint, plaster, dust and mould.

 · Drywall and other absorbent surfaces must be sized and completely left to dry.

 · Sizing should be completed at least 4 hours before. Pasting And Hanging - Paste-The-Wall

 · Refer to wallpaper manufacturers label for specific instructions. Ensure wallpaper is suitable for Paste-The-Wall application.

 · For best results use a roller to apply Wallrock FR Adhesive generously and evenly to the wall. Ensure coverage of the wall from floor to ceiling is complete.

 · Paste up to two widths of wallpaper at once to reduce decoration time and apply paper to the pasted wall.

 · Simply position the wallpaper sheet by sliding and smooth into the final place under pressure using a squeegee, wallpaper brush or damp sponge.

 · Complete hanging and trimming as normal.

 · Pasting And Hanging - Paste-The-Paper and refer to wallpaper manufacturers label for specific instructions - eg. soak time etc.

 · Protect surrounding areas (floor coverings and furniture etc) from splashes and drips.

 · Paste wallpaper generously, ensuring that edges are fully covered with the paste, allow heavyweight papers to soak until supple, (unless Paste-The-Wall products ie. Wallrock).

 · Ensure edges are stuck to the wall.

 · Remove any paste from the face of the wallpaper and surrounding area immediately with a damp cloth or sponge.

 · Clean tools and equipment in warm soapy water.

 · Not suitable for hanging borders or overlapping seams on vinyl wallpapers.

 · For best results use vinyl to vinyl adhesive for hanging borders, overlapping seams, and for repairs.

 · Contains fungicide and biocide to inhibit mould, yeast and bacteria. Keep away from children and animals. Wash hands thoroughly after use.

 · Do not empty into drains or watercourses. Waste should be disposed of using authorised disposal routes and sites.

*Further information may be found in our Downloads section.

Fairly easy access to all PDF files.

Datasheet ǀ Declaration of Performance - DoP ǀ BBA Certificate ǀ Installation Guide ǀ Certificates ǀ Brochure ǀ SPEC Sheet